I'll take care of the adjustment of the neck, upper buildings and bridge.
It is first made dry, with sanding and adding wedges, maintained with pliers.


I add a PVC L-strip on the rear rib to have a better hold of the neck.

Then the two main parts of the main buildings.

A wooden wedge ensure keeping them on their front side.

Then I go to the higher buildings, where you have to trim the details.

Sometimes there are several millimeters of material to remove...

After numerous runs to the belt sander, thickness is good, but still a wrong angle.

which is resolved after a bath in hot water (which softened the resin and allows it to be reshaped)

And finally the front building. Here too, we must trim the details to insert the part

The angle here is also incorrect

And is adjusted after a run in hot water.











It is also necessary to add plastic strip on neck so the bridge is straight.